VITROCELL Systems

VITROCELL® Flow Control Constant and defined flow of the test atmosphere over the cells is an important factor for the experiment . The VITROCELL® modules are designed to operate at low flow rates, in most cases the flow rate is 5 ml /min. In some applications higher flow rates are used. The recommended and most economical way to adjust the flow rate is to use the unique and efficient VITROCELL® flow calibration valves. The desired flow rate level is adjusted to a mass flow meter read out . Introduction Alternatively VITROCELL® offers electronic mass flow controllers. In this case one mass flow controller per cell culture insert compartment is permanently required. VITROCELL® flow calibration valves regulate the flow of the aerosol through the modules in the ml range. The valves are located between the vacuum pump and the aerosol exposure top. Mass flow meters enable accurate valve read-outs. The consistent and adjustable flow rate ranges from 0…20 ml/min. Alternative flow rate ranges are available upon request . The valves enable fast control of the flow rates prior to the experiment . They are manufactured from Teflon/stainless steel and can be easily cleaned. If the aerosol contains particles, we recommend installing disposable microfiber filters in front of the valves. VITROCELL® Flow Calibration Valves ○ Easy and quick flow adjustment ○ Economical solution ○ Can be easily cleaned Features 184

RkJQdWJsaXNoZXIy ODIzMjIz